Part 3

Adhered tissue adhesive promazyvayut not matter, and the wall. On its surface and put a layer of special composition, then the canvas tightly pressed against the wall and smooth hands. Adhered tissue composition applied to strips of width 15 - 20 cm Clay promazyvayut walls around the perimeter of the room, around door and window openings and outlets. Then the fabric is pressed to these sites. In order that the matter taut, it is desirable to make the wall slightly concave. The fabric is not settled after drying, it is fixed through the plinth and eaves with wooden planks. Nails pierce it with an interval of 7 - 10 cm to the shrinkage was minimal, the fabric before stretching wet with water, dried and how to iron. During the gluing each section of the cloth should be as smooth. The result should ideally flat surface.

Fabric can not stick, but just to nail to the wall. In this case, the matter is attached at the corners with Tolev nails, and in the middle of the walls - nails with decorative heads. The lower edge of the fabric is fixed with plinth and the upper - a wooden plank, which after the completion of camouflage decorative cornice. This mounting method is suited for any matter, but it is almost impossible to spoil.

Wall coverings begin with preparatory work. First measure the width of the tissue between the edges, then - the height of the walls from the floor or skirting a line from the ceiling and window sills, on the ceiling to the door lintel.

Amount of tissue, which will require you to trim the room, can be calculated as follows. The height of the flag is equal to the height of the walls, plus 6 cm (for the entry under the top and bottom plates), width - the width of the cloth or minus 3 cm (at the side seams). Consider an example of how such a calculation is carried out. Take the most occurring Ceiling height: 2,2, 2,5 and 2,7 m. The length of the wall - 4 pm Typically, the fabric is produced in rolls of a width of 1,5 m, the effective value was 1.47 m. For the first case the height of the flag should up 2,26 m for the second - 2,56 m for the third - 2,76 m. Thus, to upholster a wall, it will take 6.8, 7,7 and 8,3 meters of fabric. At the same time remain a small snippet that can be used to trim the space above the door on another wall. If you are planning a stud wall is not uniform, and diaper, the experts recommend to buy it for 10 - 15% more to maintain uniformity of the image. If the pattern is large, then the expense for his fitting make a greater margin: 20 - 25%. Calculating on this scheme, the required amount of tissue, you can go to the store.

Linking to cut the cloth as follows. Cuts of matter baste or fastened together with sewing pins, and then stitch on the sewing machine. Necessary to ensure that the seams gets exactly, not taxes. Edge of the fabric should be negligible. After all the flag sewn, progladte their iron. Choose that temperature which is suitable for the selected type of matter (usually on the iron has a special mark on the fabric may also be appropriate tab). Particularly careful to iron the seams. After such preparation attach the flag sewn to the wall and check that met all sizes.

After trying them, you are ready to upholstery. First, the material is fixed upholstery nails on the upper segment. The degree of tissue tension adjust snapshot. Then use a plumb-line to check how well situated cloth, observing the vertical. For this tool is applied to the seam between the sheets. Next, look at how well the fabric taut, and fasten it with nails along the bottom and sides of the segments.